Ekofires eko 5510 Troubleshooting Guide

installation and user instructionsAll instructions must be handed to user for safekeepingRevision B - 08/11Country(s) of destination - GB/IEeko 5510ek

INSTALLATION METHOD 3 (timber framed buildings)Where removal of any part of a timber frame is undertaken the structural integrity of the wall must ber

INSTALLATION METHOD 4This method allows for a ‘hole in the wall’ installation of the appliance with the rear part recessedinto the inner leaf of a cav

CHECKING THE BURNER AND SPARK GAPNon-coal effect models : There are no imitation fuel bed components to install. The appliance features aribbon burne

FITTING THE DECORATIVE FRAME, FRONT AND HOODThe appliance is supplied with a decorative frame and hood. Attach the hood using two M6 screws asshown in

SETTING PRESSUREThe pressure test point is located on the left hand side ofthe appliance, on the main burner pipe, next to the brassrestrictor/connect

CLEANING THE CERAMICSRemove the frame and front/facia and place to one side. Remove the hood. Remove the glass door assem-bly. Remove the ceramic c

CATALYSTIt is recommended that the catalytic converter is inspected for signs of damage and dirt during routine serv-icing procedures. The expected li

TROUBLESHOOTING GUIDEFire sparks but pilot does not light • No gas to fire, check isolators are open and gas supply is on.• Pipework blockage, clean o

USER INSTRUCTIONSSection Contents Page No1.0 Important Notes 12.0 Fire Front/Facia 23.0 Clearances to Combustibles 24.0 Ventilation and Room Size 35.0

FIREFRONT/FACIAThis fire is supplied with a particular style of fire front. Use of the fire front will ensure an adequate air-flow under the firebox

Eko 5510© 2009 Focal Point Fires plc.Eko 5520Eko 5530

VENTILATION AND ROOM SIZEPurpose provided ventilation of 100cm2is required for this appliance. An openable window or equivalent isalso required. Any v

FITTING THE FUEL BED (where applicable)The appliance features a features a coalstyle fuel effect.1. Place the rear coal strip onto the shelfbehind the

INSTALLATION INSTRUCTIONSIMPORTANT NOTESThis appliance is a high efficiency, flueless catalytic flame effect gas fire. It provides radiant and convec

APPLIANCE DATAINSTALLATION REQUIREMENTSThe fire has been designed to be installed in two main applications; either to fit into a suitable opening cre-

SITE REQUIREMENTS (continued)Basic opening sizes (all dimensions in mm)The basic opening dimensions for the appliance are as follows; The opening must

SITE REQUIREMENTS (continued)Clearances to non-combustiblesNon combustible surfaces are defined as brick, metal, marble, concrete etc. and also a numb

VENTILATIONA minimum of 100 cm2purpose provided ventilation is required for this appliance. This may be achievedeither with one vent 100 cm2at a high

GAS SUPPLY ROUTESFollowing preparation of the fixing method, the concealed gas supply (if required), can now be installed. When the opening is ready f

INSTALLATION METHOD 2 (recessing into a non-combustible wall)This method allows for installation of the appliance with the rear of the firebox recesse